Raspberry Pi Zero Eagle Footprint / LBR

[peter6960]

I created an Eagle footprint for the Zero:

Hope you find it useful

[TonyD]

Thanks for sharing.

[inches]

I'm opening these up in Eagle 8.1.0 and notice that when I place the schematic in my schematic the board doesn't show up on my board linked to it. Is this a version issue for Eagle 8.1.0, am I using the lib wrong, or were they ever hooked up like that?

[George Twiceight]

Used today in Eagle 8.1.0 and it shows up perfectly. I don't know the cause of your issue. Which kind of license do you have?

[pierrot10]

Dear Peter

Thank for that PCB.
I am doing an hat for a Raspberry Zero W. I never know the min width of a route
For know I select 0.3

Second stupid question: from where can I define the unity. I supposed 0.3 are not millimter?

Many than ofr your help

[aarkay14]

Can I reqeust the OP to provide the SMT footprint as well. I can see that this one has THT footprint only!

-Rama

[DirkS]

Can I reqeust the OP to provide the SMT footprint as well. I can see that this one has THT footprint only!

Of course you can, but OP has not logged in to the forum for more than 3 years...